Hi, I am a student at the Faculty of Engineering and I have a project I have drawn on the SolidWorks but I tried very hard to draw two tap but I failed in that I wish I could help me draw it and be thankful for it. The diameter of each is 20 mm.
hello, please share the drawing
Share drawings and some more pictures
Also if u could send Hand sketch that will be also fine
If anyone wants to send the full picture and install the taps, send the email please. Thank you so much guys
Find everything at the bottom
U need only 2 taps in Solidworks?
Can I send me tap sketches on my mail?
I can do it men just need you email
thanks a lot bro.
That's what I need to do
ok man , i will do
thank you man
that is the correct
bro I need more information
All I care about is drawing these two only and do not care about the external dimensions to be real only be small and ride in the cell designed by me.
You can assume its size because it is not close to me
I've finished designing this. I just need that tow things
check you email
soo sad :(
what is your version?
If you don't receive the email within an hour (and you've checked your Spam folder), email us as firstname.lastname@example.org.