Solidworks metric gauge table k-factor
I'm trying to set up a gauge table in solidworks with k-factor.
I have a list with a k-factor and internal radius per thickness.
See below, but when I try to use this table in solidworks, the internal radius is rounded of to whole mm's.
I need this to stay at 4,6mm instead of 5mm.
Any way to solve this issue?
Thanks in advance,
Mark
1 Answer
Hello Mark!
The angle ist the bending angle not the openig angle. Try more bend angles (maybe up to 150 degrees). Maybe it helps.
I wish you success
Leo
