SolidWorks Tutorials on Demand

Created by Usman Akhtar on 7 March, 2018

How do I get the drafting to be negative in the hole?

I'm trying to get a negative draft in the hole but when it is a negative draft, it is not correctly shown.

The one that says Flange - Casting is how it should look.

The one that says Flange - Casting Drawing is how it looks right now.

If I make it look like the one that says Flange - Casting then I get a positive draft, which I don't want. How can I get this fix?

1 Answer

Hello bro..
I'm Ahmed Elprince..
Use draft feature and reverse the direction of pull then it will adjusted!..
if you did that so you can use parting line type and select the edge of the cylinder you gonna draft from..
but I'm sure about that it's gonna be adjusted..
if any problem occured tell me