Is it possible to create a sketch or feature and suppress it, and use it as a point to constrain in the assembly.

I will upload the part later when I am at the office.

4 Answers

Yes you can . One suppressed one normal.

Let me explain a bit further. I have two scenarios.

I have three components. A scaffold upright, ledger and steel board. I can constrain the edge of the wedge hole on the ledger to connect to the edge of the v pressing on the upright. But the problem is, when I do that, it isn't in the center. I try and explain in the photos attached.

My other problem is I need to constrain the steel board, to fit onto the ledger at a certain spacing as attached photo.

I have no problems using the normal contraints available.

I used center ,Flush and tangent contraints