Tutorial how to make engine part 5

Aykut Dana

23 Feb, 2012 08:19 PM

Crank oil canal

1. Step 1:

   rollback the feature tree up to mirror1
   

   

2. Step 2:

   use 3D sketch and draw a line. starting point and endpoint have to be center of the circles
   

   

3. Step 3:

   delete the relations
   

   

4. Step 4:

   enter z coordinate -5
   

   

5. Step 5:

   enter z coordinate 20 for this point
   

   

6. Step 6:

   add a plane ( referance geometry>plane then select line and endpoint)
   

   

7. Step 7:

   draw shown circle on this plane
   

   

8. Step 8:

   use cut extrude command
   

   

9. Step 9:

   open a sketch on shown surface and draw a circle
   

   

10. Step 10:

    use cut exturde command
    

    

11. Step 11:

    now open a sketch on the green surface, draw a circle and use cut extrude command
    

    

12. Step 12:

    open a sketch on the right plane and draw shown sketch. then use cut extrude command and cut the body
    

    

13. Step 13:

    roll forward the feature tree and open a sketch on the right plane
    

    

14. Step 14:

    draw shown sketch then use cut extrude command
    

    

15. Step 15:

    use fillet command
    

    

16. Step 16:

    crank is ready now