Tutorial on Modeling Bearing in SolidEdge
Here is the tutorial.
-
Step 1:
Start SolidEdge.
-
Step 2:
Click ISO Part to start part modeling.
-
Step 3:
The Part modeling workspace will show up.
-
Step 4:
Click Circle.
-
Step 5:
Enable all base reference plane for better plane selection. Now hover on XY plane and press F3 to lock it.
-
Step 6:
Keep the mouse pointer on the base and then click it.
-
Step 7:
Enter diameter 50mm and press enter.
-
Step 8:
Again select the circle.
-
Step 9:
Along X axis.
-
Step 10:
Draw a circle of 30mm.
-
Step 11:
Draw a circle of 30mm on other side too.
-
Step 12:
Click Smart Dimension.
-
Step 13:
Select Y-axis.
-
Step 14:
Select the circle.
-
Step 15:
Enter dimension of 35mm.
-
Step 16:
Repeat the same step for other circle.
-
Step 17:
Click Line tool.
-
Step 18:
Enable Tangent under sketching tab.
-
Step 19:
Draw a line tangent to the two circles.
-
Step 20:
Repeat the same step for other circles. If needed add tangent relation.
-
Step 21:
Select trim tool.
-
Step 22:
Trim all the inside elements.
-
Step 23:
Click Select tool and then click inside the region of the sketch and extrude it by 10mm.
-
Step 24:
Again select the circle tool and press F3 to unlock the top plane and then select the top face face and then lock it.
-
Step 25:
Draw a circle concentric to the middle circle.
-
Step 26:
Click inside of it and then extrude it by 28mm.
-
Step 27:
On top face click with circle and then draw a circle of 30mm.
-
Step 28:
Extrude it with remove at 6mm downwards.
-
Step 29:
Select circle tool and then click on the 2nd number top face
-
Step 30:
Draw a circle of 20mm dia.
-
Step 31:
Extrude it with remove material through all.
-
Step 32:
Select circle tool and then this face.
-
Step 33:
Draw two circles of 12mm dia concentric to edges.
-
Step 34:
Extrude both of them with remove and through all.
-
Step 35:
Enable right plane and then select Circle tool. Lock on the right plane and then along Z axis.
-
Step 36:
Draw a circle of 6mm dia.
-
Step 37:
Smart dimension it by 12mm to the top edge.
-
Step 38:
Extrude it with remove.
-
Step 39:
Through all.
-
Step 40:
And the part is complete.