How quick can we model this in catia?
5 Answers
according to me, it can be draw by rolled wall in sheet metal in which you can draw cross-section of this profile and give length with sheet thickness and after it you can go for slots or cuts.
first we need to sweep
& select the surface & go to sketch, draw the sketch
and pocket
it will finish within 5 minute
It can also be done with Part Design (solids) just as fast and easy as Umesh said.
It can also be done with Sheetmetal workbench, but might take twice as long (more steps), but you get a flat pattern.
If you are good, I would say 10minutes start to finish, 5minutes if you was "racing".
If you are interested I can create you a video of me doing this. Just request this from us at www.intrinsys.com
it is so easy what you can do is just draw the side 1st end then do pad then just make 1 slot of square and 1 hole and then pattern it its done it will take less than 5 min
