How to make a rifling grooves in Solidworks?
Follow the steps below...
-
Step 1:
Using front plane to sketch a circle, 200mm in Dia. and extrude it according the setting as shown...
-
Step 2:
Sketch a circle on the front plane that snap with the inner circle of the tube (same Dia. with inner circle).....and exit sketch~
-
Step 3:
Click on the "Helix and Spiral" under the Curves command, and select the circle that you had sketched just now.....Next, follow the setting bellow, and OK with it~
-
Step 4:
Sketch a point on front plane as a reference...and follow the next step~
-
Step 5:
...sketch as the pic. shown
-
Step 6:
Click on Swept-cut, and follow the setting bellow...
-
Step 7:
Next click on the "Axis" under Reference Geo. command....and follow the setting as shown...
-
Step 8:
Click on Circular Pattern and follow the setting....
-
Step 9:
Finally....Walla!