Pin
Design of a Basic Pin
-
Step 1: Sketch for the Pin
Click on sketch command & select line. Then draw the this sketch as given above.
-
Step 2: Revolve Boss-base
Now click on Revolve Boss-bass command from the Feature Tab in Command Ribbon. Then, select the blue line as shown in above pic. Then click on done.
-
Step 3: Sketch for Hole
Now, select Front plane and sketch a circle as shown above.
-
Step 4: Extrude cut
Now, go to Feature Tab and select Extrude- Cut command.
Then select the direction1 as THROUGH ALL-BOTH.
Click on OK.