Tutorial how to make engine part 11

Aykut Dana

24 Feb, 2012 10:02 PM

Cylinders - 2

1. Step 1:

   open a sketch on front plane and draw water canal profile
   

   

2. Step 2:

   extrude it
   

   

3. Step 3:

   create a plane bottom of body and use mirror command for to mirror water canal
   

   

4. Step 4:

   after open a sketch on this surface
   

   

5. Step 5:

   draw a sketch like this and use cut extrude command
   

   

6. Step 6:

   go to left side, open a sketch and draw a sketch like this
   

   

7. Step 7:

   extrude it. please attention that to make direction 'up to surface'. select the outer surface of the cylinder
   

   

8. Step 8:

   open a sketch on same surface and draw semi-circular profile. it have to be closed profile
   

   

9. Step 9:

   create the plane 3 ( it is at the center of water canal) then draw the path.( we will use sweep command)
   

   

10. Step 10:

    use sweep command. then mirror it
    

    

11. Step 11:

    create a inlet part like this
    

    

12. Step 12:

    close the back side with your method
    

    

13. Step 13:

    mirror all things and your water cooled 12 cylinders are ready