I will divide into two stages one type of outer ring then inner ring only remaining seals, but I do not know what mechanism to remove them
There are number of apps that can separate your stl. I use Blender and AdMeshGUI to break them apart personally.
I guess the first solution is to make improvement on the part molding. In a lot of cases you can do molding and cutting at the same time.
As a second solution, use a steel-rule cutting-die, they make circular punch dies as a standard size, it might match your diameter. You can make a full or a section cutting-die, and they are not expensive. If you buy the punches you can make it yourself by using a wood die board.
Can you share more 3D pictures about it?
I an sending you a sample, it may not work for what you want. The solution for your problem is in the molding, you must mold the part clean without the flash on the parting line. https://www.wagnerdiesupply.com/Images/Punches-Tech-Grp-2-2018.jpg
how to position correctly?
it is imperative to cut it all in one go
I recommend you make a sample of 4 cavities to test. As far as the "position" I am assuming you have the center-lines of the "position". Once you tested with the 4 cavity then you can proceed with all of the parts in one cut operation. Again, you must look at the molding of the parts, it seem you need a stronger press (more tonnage) to mold the parts.
Also, you mention to cut "correctly" you can make an individual floating cutting die, meaning, all parts are floating separately.
If you don't receive the email within an hour (and you've checked your Spam folder), email us as confirmation@grabcad.com.