Models
Work experience
C295 & CN235 Operability Engineer
Airbus Defense & Space
•
April 2021 - present
‣Operational information management, maintenance, and configuration of the C295 and CN235 fleets.
‣Giving components efficiency feedback to the military operators of these fleets.
‣VBA is the most common technical tool in this job, together with the entire Microsoft Office package.
Junior Consultant & Engineer, R&D Division (Ni+Do)
Altran
•
September 2019 - September 2020
External academic internship at the R&D division, related to the development of an electrical aircraft jet engine propulsion and the following functions:
‣ Aerodynamic functions (Ansys Fluent/Acuconsole meshing with Hypermesh). Steady and Transient simulations were done, with two rotating meshes (fan and compressor blades).
‣ Aeronautical design (Catia V5).
‣ Documentation of the work performed (Microsoft Office).
Recommendation letter is available from my supervisor at Altran.
Education
Motor & Sport Institute
Master, Motorsport Engineering
•
January 2021 - January 2022
The master focuses on all areas of motorsport, including vehicle dynamics, aerodynamics/CFD, advanced design & CAD, data acquisition, etc. In the future, I will be involved in the development of the setup of a Formula 4 in the Spanish F4 Championship.
‣The main softwares: Catia V5 (CAD), XFlow and Star-CCM+ (CFD), Abaqus (Structural design), AVL/VSM Drive (Vehicle Dynamics Simulation).
Technical Superior School of Aeronautical and Space Engineering (ETSIAE)
Bachelor, Aerospace Engineering
•
January 2014 - January 2020
‣Final degree project: Preliminary design of a 7 MW Wind Turbine [9/10], done with Matlab.
‣Knowledge in a wide range fields in the aeronautical sector: Fluid mechanics, CFD, Aerodynamics, Aeroelasticity, Vibrations. The fields highlighted are extremely important in the Motorsport sector.
